Features

• One Mic/Line XLR Input and One Mini-jack Input on Front Panel
• Terminal Block for Two Audio Outputs on Rear Panel
• Mini-jack Input is set to Mono signal
• Converts Mic or Line Audio Signals to Dante Network
• Mic or Line is Selectable for XLR Input 
• Switchable 48V Phantom Power for Mic XLR Input
• Adjustable Mic/LIne Gain from -20 dB to +20dB for Each Input Channel
• Two Audio Signal Outputs from Dante Network  
• Balanced or Unbalanced Signal Outputs
• High Resolution 24 Bit for DAC and ADC
• Power over Ethernet (PoE) or 24VDC power supply
• Provides High Quality of Preamplifier for Microphones
• Dimension: 87mm x 87mm x 53.1mm (WHD)

Specifications

    Dante Network to Line /MIC Outputs

* Outputs : XLRx2, 5P Detachable Terminal block 

* Output Level:   -10 dBu nominal (Line)

              -10 dBu nominal (MIC)

* Output Level:   +10 dBu Maximum

* Output Voltage:  +20dBu (@ 0dB output gain)

* Output Impedance: 150 Ω balanced; 75 Ω unbalanced 

* Frequency Response: 20 Hz to 20 kHz (± 0.5 dB) 

* THD+N: < 0>

* Noise: <-75dB 

* Crosstalk: < 85>

    Mic/Line Inputs to Dante Network 

Mic Inputs 

* Inputs: XLR x 2 

* Gain: Condenser microphone : 40 dB

* Dynamic microphone : 60 dB

* Input Level for +4 dBu: -36 dBu (Condenser)

                                       -56 dBu (Dynamic) 

                                       -36 dBu (Maximum)

* Input Impedance: 40 Ω 

* Phantom Power: 48 V 

* Frequency Response: 20 Hz to 20 kHz (± 0.5 dB) 

* THD+N: < 0>

* Noise below +4 dBu: < -70 dB 

* CMRR: > 70 dB (50 Hz to 120 Hz) 

* Crosstalk: < 70>

Line Inputs 

* Inputs : XLR x 2 

* Input Level for +4 dBu: +4 dBu (balanced); -10 dBV (unbalanced) 

* Input Impedance: > 40 Ω 

* Frequency Response: 20 Hz to 20 kHz (± 0.5 dB) 

* THD+N: < 0>

* Noise below +4 dBu: < -75 dB 

* CMRR: > 60 dB (50 Hz to 120 Hz) 

* Crosstalk: < 75>

                   < 70>

* Headroom above +4 dBu: > 18 dB 

    Dante channel

* Transmitters/Receivers: 2/2

* Transmission rate: 100 Mbps

* Resolution:  16/24/32 Bit

* Sampling rate:  44.1 kHz, 48 kHz.

* Dante interface: RJ45 jack 

* Power Connections : 2 Pin Euro Terminal, Power Jack 

* Power Requirement: 24 Vdc @ 180 mA plus connected phantom loads, or PoE

* Dimensions: 87mm(W) × 87.5mm(H) × 53.1mm(D) 

* Weight: 0.28 Kgs 

Documents

DIC2223A DIC2223AU Manual.pdf