Features

•Two Channels Model – 120W RMS.
•Stereo into 4-8 Ohm loads.
•Bridgeable for 70V or 100V (Direct Drive)
•Slot card for Dante Receiver.
•Power down after ~15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby.
•Yellow LED ( Front Panel) to indicated Standby mode is active.
•Terminal Block analog audio inputs on 2 CH amp.
•2 x amplifier outputs, bridgeable to 1 channel.
•Volume, Auto on/off signal sensing.
•Natural cooling without Fan.
•TRIGGER could be external remoting ON/OFF.
•Short circuit protection.
•Overheating protection.

Specifications

•Output Power:

120W x 2, 8 Ω (31 V) RMS @ < 1>

120W x 2, 4Ω (22 V) RMS @ < 1>

240W, 70V @ < 1>

240W, 100V @ < 1>

•Frequency Response: 20Hz~20KHz, +/- 2 dB @ 4Ω Load

•S/N:>90dB  @ 1W(20 Hz - 20 kHz)

•Input Sensitivity: 1.0V (+2.2dBu) @ Max Output 4Ω

•Gain: 25 dB @ 4Ω

•Input Impedance: >10K Ohm, Balanced

•Maximum Input Level: 12.3 V (+24 dBu)

•Trigger In/Out: DC 12V

•High Pass Filter: 80 Hz(±2dB)

•Input Connector: 5 pin Euro terminal

•Trigger Connectors: 3.5 mm Jacks

•Output Connectors:

4 pin Euro terminal (4Ω/8Ω) 

2 pin Euro terminal (70V/100V)                    

•Power Requirements: 100 - 240 VAC, 50 - 60 Hz, 350W

•Dimensions: 214mm x 249.8mm x 44mm (WxDxH)        

•Weight: 1.94 Kg

 

Dante Audio Interface

•2x2 audio channels

•I2S digital audio format

•16, 24 or 32-bit audio samples (per device or per channel)

•44.1 KHz, 48KHz, 88.2KHz and 96KHz sample rates

 

Network Interface

•Standard 100Mbps Ethernet

•RMII Ethernet interface with MDIO

•Hardware time-stamping, supporting sample-accurate playback

•Transmit flows: 2 (unicast or multicast)

•Receive flows: 2 (unicast or multicast)

•Latency from 2ms

Documents

PLA2Di - DM.png