簡體 繁體 english menu
  • ABOUT
  • Products
    • Home Installation
      • Amplifier
      • Solution Boxes
      • 2.4G Wireless System
      • Power Management
      • Speaker Selector
      • Speaker
    • Public Address
      • Speaker Selector
      • Amplifier
      • CSP Transceivers
      • CSP Receivers
      • Matching Transtormer
      • Solution Boxes
      • Speaker
      • Gooseneck Microphone
    • Discontinued
      • Amplifier
      • Crossover
      • Equalizer
      • Processor
      • Power Conditioner
      • Speaker
      • DJ Mixer
      • Gooseneck Lights
    • Pro Audio
      • Amplifier
      • Mixer
      • Headphone Amplifier
      • Guitar Tool
      • Mini Mixer
      • Direct Boxes
      • Mic Preamp
      • Phantom Power Supplie
      • Other Solution
  • NEWS
  • SERVICES
  • CONTACT
PLA2



Power Amplifier




PLA2

Power Amplifier

Features

•It used 9.5 inches special tiny design.
•Two Channels Model – 120W RMS/Per channel.
•Stereo into 4-8 Ohm loads.
•Bridged mode 240W output for 70V or 100V (Direct Drive)
•Power down after ~15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby.
•Red LED ( Front Panel) to indicated Standby mode is active.
•Terminal Block analog audio inputs.
•Selection for Power-Up mode.
•Switch for High Pass Filter.
•.Natural cooling without Fan. 
•TRIGGER could be external remoting ON/OFF.
•Short circuit protection.
•Overheating protection.

Specifications

•Stereo Mode (all channels driven)
•120W x 2, 8Ω (31 V) RMS output (steady state), per channel @ < 1 % THD+N
•120W x 2, 4Ω (22 V) RMS output (steady state), per channel @ < 1 % THD+N
•Bridged Outputs For 70V/100V (Switch at “HIZ” position)
•240W, 70V @ < 1 % THD+N
•240W, 100V @ < 1 % THD+N
•Frequency Response   20 Hz - 20 kHz, +/- 2 dB @ 4Ω Load
•Signal to Noise           >90dB  @ 1W(20 Hz - 20 kHz)
•Input Sensitivity         1.0V (+0dBu) @  Max Output 4Ω
•Gain Value             25 dB @ 4Ω
•Input Impedance       >10k, Balanced.
•Maximum Input Level  12.3 V (+24 dBu)
•Trigger In/Out           DC 12V
•High Pass Filter          80 Hz(±2dB)
•Input Connector         5 pin Euro terminal
•Trigger Connectors     3.5 mm Jacks
•Output Connectors     4 pin Euro terminal (4Ω/8Ω)
                                 2 pin Euro terminal (70V/100V)
•Dimensions               214mm(W) x 249.8mm(D) x 44mm(H)
•Net Weight               1.94 Kg 
•Power Requirements   100 - 240 VAC, 50 - 60 Hz, 350W

Documents